Found a slimmer, less brick like, power bank. (Tried a smaller model by Ugreen but it would not power up the Fnirsi)
2 Likes
Nooo! What happened?
I clumsily knocked it over in Sherlock but have another on order.
Hey bros,
The Turbo is basically an upgraded G43 that now works as an 18mm injector and is no longer loaded natively, you use a separate bowl with it.
This batch is going to be limited to 100 units, I’m still building these myself and they can take a while to make. Once these are all built I’ll be working on the next iteration of the G, which will have better availability.
The waitlist for these is currently full, but it’s possible that spots could open up. I’ll keep you guys posted.
The Turbo G43 is an 18mm injector-style vaporizer designed for high performance and efficiency. Each unit is hand-built using USA-made borosilicate glass, a 316L stainless steel heating coil, and “white sapphire” synthetic corundum balls (clear rubies).
These are the main differences between the two models:
Original G43:
- Developed in 2018
- 25mm long heating element
- Borosilicate balls
- Runs at ~12 watts
- Bowl and heater are one piece (you load herb into joint of slide)
- Ground glass joint
- Optimal load size of 0.2-0.25g
Turbo G43:
- Developed in 2023, revised in 2026
- 47mm long heating element (approx. entire length of slide)
- White sapphire balls (clear rubies)
- Runs at ~18-22 watts (50%+ more power)
- Load ground herb in separate bowl (18mm or 14mm available)
- Polished glass joint
- Optimal load size of 0.1-0.15g
Usage
The Turbo G43 works with any glass rig or j-hook, large or small. A variable-voltage power adapter is required. It should be adjustable up to 12V and rated for at least 5A. Basic wall adapters are inexpensive and widely available (~$20).
- Voltage: The recommended voltage range is 7.0V to 7.8V, with 7.2V being a good starting point. Do not exceed 8.0V. Initial heat-up time from cold start is 6 minutes.
- Load Size: The recommended load is between 0.1g and 0.15g, with a maximum capacity of 0.25g.
- Draws: You can expect 2 to 4 draws from a typical load. Resistance is below average. No wait required between draws.
- Stirring: It is recommended to stir the herb or shake the bowl between hits, ensuring your material is level on the screen.
- No Burn-off: During the build process I bring each unit up to operating temperature two times, so you do not need to do a burn-off before using it.
More detailed information can be found on my website here: G43 Vaporizer (Turbo G) – Vaporize.com
19 Likes
appreciate you joining up and posting bro!
5 Likes
We should get that info in the OP, yes?
3 Likes
I set OP as wiki so anyone with basic trust level can do it
1 Like
Will there be another batch of these for those who missed out?
1 Like
I’m on the waitlist to. 
3 Likes